Ruijie Community

Title: DHCP Address Management(AM) rules [Print this page]

Author: admin Time: 2017-5-3 17:46
Title: DHCP Address Management(AM) rules
DHCP Address Management(AM) rules.

Author: admin Time: 2017-5-3 17:46

Functions of the AM rules:

The AM rules are used to allocate network segments based on VLANs and ports.
One DHCP pool can be configured with only one network range, which cannot satisfy the refined address management, especially in the super VLAN deployment scenario on the simplified network.
Compared with the DHCP pool, the configurations of the AM rules are simple and achieve better effects with less command lines.

Is the AM rule mandatory for the DHCP pool?

No. It is suggested to configure the AM rule for the DHCP pool.

Can part of the DHCP pools use the AM rule while the other part uses the traditional mode?

Not available in the earlier versions. Once the AM rule is configured for a DHCP pool, all DHCP pools on the network should be configured with the AM rule. Otherwise, addresses cannot be applied. This is a defect of the solution.
This issue is addresses in the version 11.0(1)B2 Build(10) released in early October. In this way, both AM rules and traditional rules can co-exist. Therefore, the AM rule configuration for the DHCP pool is not limited.

How to configure the VLAN that adopts the AM rule in DHCP relay scenario or no switchport scenario?

The VLAN of the AM rule is set to the service sub VLAN of the user.
In no switchport scenario, the VLAN matching is unavailable. Only port matching is available.

Welcome to Ruijie Community (https://community.ruijienetworks.com/)

Powered by Discuz! X3.2