Title: Stopped working after applying configurations [Print this page] Author: donets@arena-mo Time: 2021-6-2 14:37 Title: Stopped working after applying configurations Edited by donets@arena-mo.ru at 2021-6-2 14:39
[size=14.6667px]Good day! After applying the settings on the ports, I stopped connecting to the switch. There were attempts to reset the settings through the console, now it is completely unmanageable even through the console.
[size=14.6667px]
The device may enter testing mode, please try to refer to the following guide to recover1. restart switch
2. press Ctrl+C to enter uboot
3. key in 4, --》4.scattered utilitles
4. key in 3, --》3.advanced settings
5. key in 6, --》6.Set RGOS mode
6. will show the following output
Switch RGOS to factory mode.
Erasing SPI flash...Writing to SPI flash...done
And then you can restart the switch. It will work.
Welcome to Ruijie Community (https://community.ruijienetworks.com/)
