Ruijie Community

Title: Why No NAT Entries Are Displayed After the show ip nat translation Command Is Executed on an RSR77 Router? [Print this page]

Author: admin Time: 2017-5-4 12:35
Title: Why No NAT Entries Are Displayed After the show ip nat translation Command Is Executed on an RSR77 Router?
Why No NAT Entries Are Displayed After the show ip nat translation Command Is Executed on an RSR77 Router?

Author: admin Time: 2017-5-4 12:35

The RSR77 router is a distributed router. Network address translation (NAT) entries can be displayed by using either ofthe following methods:

1. Add the slot ID for the outside interface to the router host by running a command such as Ruijie#sh ip nat translations slot 2/1.

2. Access the line card mapped to the outside interface and run the show ip nat translation or show ip fpm flow (which displays NAT streams or non-NAT streams) command to display NAT entries. For example:

Ruijie#vtty 3/1

[LC3/1]>en

[LC3/1]#show ip nat translation

Note: The show ip nat translation command may return many results, which are displayed by screen. If the pipe operator(|) is added to the end of the command to filter results, the results will not be displayed by screen, which may result in frequent screen refresh. The show ip nat translation command may affect services on a device with many sessions; therefore, do not use the command during peak hours.

Welcome to Ruijie Community (https://community.ruijienetworks.com/)