Title: How to configure Loop Prevention on NBS series switch? [Print this page] Author: GTAC-Harvey Time: 2021-8-27 00:12 Title: How to configure Loop Prevention on NBS series switch? How to configure Loop Prevention on NBS series switch?
Step 1: Choose Advance→RLDP, enable RLDP on RLDP setting page.
Step 2: Enter the RLDP Management Page, you can see the Loop Detection status and Action for the port.
You can click Edit to change the status and Action
When the loop occurs, you can see on the RLDP Info interface, the port that generated the loop, their port status
is Error, and the opposite port of the loop with this port will be indicated in the Neighbor Port.
When the loop is eliminated, the ports where the loop occurred before, maybe their port status are still Error.
The error state will be restored to the normal state when the errdisable recovery interval time arrives
