Ruijie Community

Title: How to login the eweb management for EW Mesh Wi-Fi? [Print this page]

Author: GTAC-Sam    Time: 2022-3-3 10:48
Title: How to login the eweb management for EW Mesh Wi-Fi?
Connecting to the Router
You can open the management page and complete Internet access configuration only after connecting a PC or a mobile phone to the router. You can connect a PC to the router in either of the following ways and connect a mobile phone to the router in wireless connection mode.
Connect a local area network (LAN) port of the router to the network port of the PC and configure Obtain an IP address automatically on the PC. The EW300 is used as an example. The following figure shows the connection between the router and laptop.


On a mobile phone or laptop, search for a Wi-Fi network @Ruijie-sXXXX (XXXX is the last four digits of the MAC address of each device). The default SSID and login address can be found on the bottom label of the router.
Logging In
When a PC or a mobile phone connects to a router in initial state, the configuration wizard page appears. If the configuration page does not appear, enter the device IP address into the address bar of the browser to navigate to the login page, and then enter the password for login.

If you forget the IP address or password, hold down the Reset button for more than 5 seconds to restore factory settings. Then you can use the default IP address and password to log in.
Noteļ¼š
Restoring factory settings will delete existing configuration, and you are required to configure Internet access again at your next login. Therefore, exercise caution when performing this operation.
If the router in initial state detects that the IP address of the primary router is 192.168.110.1, the router automatically changes its own IP address to 192.168.111.1 to avoid an IP address conflict. You may fail to log in to the router during the IP address change but can reconnect to the Wi-Fi network and complete configuration 1 minute later.





Welcome to Ruijie Community (https://community.ruijienetworks.com/) Powered by Discuz! X3.2