Ruijie Community

Title: After a Member Interface of the N18000 Exits from an AP Aggregate Port, Why Cannot the Member Interface Be in the Up State If No Configuration Is Performed? [Print this page]

Author: admin Time: 2017-5-3 16:03
Title: After a Member Interface of the N18000 Exits from an AP Aggregate Port, Why Cannot the Member Interface Be in the Up State If No Configuration Is Performed?
After a Member Interface of the N18000 Exits from an AP Aggregate Port, Why Cannot the Member Interface Be in the Up State If No Configuration Is Performed?

Author: admin Time: 2017-5-3 16:04

After a member interface exits from an AP aggregate port, the shutdown command is automatically executed on the member interface to prevent loops.

Welcome to Ruijie Community (https://community.ruijienetworks.com/)