Title: How to configure IP-based rate limiting on the new Ruijie Cloud? [Print this page] Author: linyonghang1@ru Time: 2023-8-11 10:21 Title: How to configure IP-based rate limiting on the new Ruijie Cloud? 1.What is the IP-based rate limiting?
IP-based rate limiting is used to limit the rate of a single IP or IP range. You can limit both application and rate.
Note:IP-based rate limiting function supported by Reyee and Ruijie Gateways
2.How to configure it on the new Ruijie Cloud?
1)Topology(EG105GW-X is used as an example)
2)Enter your project through the new Ruijie cloud. Click Network-Wide---Traffic Control
3)Click To configure under 1 Flow Control
4)Select Template as your environment and configure wan port rate
5)Clicek Custom traffic control policy---Add---IP Traffic Control
6)Custom traffic control policy (Take a single IP address as an example)
Note:Overall rate limit: Indicates that all users(all IP addresses in an address range)share the configured uplink and downlink bandwidths, and the bandwidth of a single user is not limited.
Per IP rate limit: Indicates that all users(all IP addresses in an address range) share the configured uplink and downlink bandwidths, and the maximum bandwidth of a single user can be limited.
7)check the policy
8)Verify configuration
Before enable
After enabling
Author: troy@tronic.com Time: 2023-10-23 17:43 Thankyou very helpful
Welcome to Ruijie Community (https://community.ruijienetworks.com/)
