Ruijie Community

Title: How to enable load balancing between AP radios on AC? [Print this page]

Author: admin Time: 2018-4-12 00:50
Title: How to enable load balancing between AP radios on AC?
How to enable load balancing between AP radios on AC?

Author: admin Time: 2018-4-12 00:51

Under AP-config mode:

inter-radio-balance flow-balance enable //Based on flow

inter-radio-balance num-balance enable //Basedon the number of users

You can configure the inter-radio loadbalancing parameters (optional) on AC based on actual requirements duringnetwork optimization.

Run the inter-radio-balanceflow-balance dual-band enable-load en-num threshold thrs-num command toconfigure the enabling threshold of flow-based load balancing between radios ofdifferent bands. The lower the threshold, the easier the flow balancing can beenabled and the more even the flow is allocated.

Run the inter-radio-balanceflow-balance same-band enable-load en-num threshold thrs-num command to configurethe enabling threshold of flow-based load balancing between radios of sameband. The lower the threshold, the easier the flow balancing can be enabled andthe more even the flow is allocated.

Run the inter-radio-balancenum-balance dual-band enable-load en-num threshold thrs-num command toconfigure the enabling threshold of number-based load balancing between radiosof different bands. The lower the threshold, the easier the flow balancing canbe enabled and the more even the flow is allocated.

Run the inter-radio-balancenum-balance same-band enable-load en-num threshold thrs-num command toconfigure the enabling threshold of number-based load balancing between radiosof same band. The lower the threshold, the easier the flow balancing can be enabledand the more even the flow is allocated.

Author: zhangyuetao Time: 2018-4-16 10:33
this very good

Welcome to Ruijie Community (https://community.ruijienetworks.com/)