Ruijie Community

Title: How to sync line card firmware version for Chassis while plugging in new card [Print this page]

Author: Oscar Time: 2018-6-26 11:57
Title: How to sync line card firmware version for Chassis while plugging in new card
Edited by Oscar at 2018-6-26 11:58

Problem:While plugging a new line card or replacement, if the line card firmware version is mismatch with control engine(CM) card. It will prompt the warning message like this:

Solution:

1.Download exact RGOS firmware file which chassis is running on USB's root direction and insert your USB to chassis.

2.Run reset command to reload the new line card, and chassis will upgrade it automatically after probing.
N18-Core#reset module 1/1------1/1 means slot 1/1

3.Exec "show upgrade status" to verify upgrade process

4.Once the firmware upgrade is finished, exec the reset command again and the new line card will be loaded.
N18-Core#reset module 1/1------1/1 means slot 1/1

2eac697b-9b16-4b5b-8a14-5f6132d309d6.jpg (137.22 KB, Downloads: 166)

Welcome to Ruijie Community (https://community.ruijienetworks.com/)