Title: How to set up connection for IP Cam while connecting with AP630 [Print this page] Author: Oscar Time: 2018-7-5 15:44 Title: How to set up connection for IP Cam while connecting with AP630 Edited by Oscar at 2018-7-5 15:56
Before You Start
POE out feature for PD device on outdoor AP630 requires HPOE power supply for RG-AP630, please verify whether the POE switch support HPOE(802.11bt) or not if IP Cam cannot be powered up.
1. Click Wizard and choose "Bridge Mode" on FAT AP EWEB.
2. Fill in an IP address for AP management.
3. Configure Access Mode(singal service) or Trunk Mode(multi service) on HPOE Switch's port as to allow all service traffic passthrough.
FIT AP
1. Ensure AP630 is online on hardware controller and ready to be configured. For more information on how to make AP online, please click here: https://www.ruijienetworks.com/support/documents/slide_58903
2. Edit designated AP and configure VLAN id for these LAN ports on Controller EWEB.
3. Configure the port which is connected to AP630 into "Trunk Mode" (services VLANs need to be allowed) and Native VLAN should be modified into AP management VLAN on HPOE Switch.
Welcome to Ruijie Community (https://community.ruijienetworks.com/)
