|
It is recommended that VLAN pruning be performed. Configure the port on the access switch used to connect to the AP as a trunk port, set the native VLAN to the AP VALN, configure theaccess switch to only transmit data from the wireless STA VLAN and AP VLAN. Access switch : (config)#interfacegigabitEthernet 0/2 Access switch : (config-GigabitEthernet 0/2)#switchport mode trunk Access switch: (config-GigabitEthernet 0/2)#switchport trunk native vlan 20//You mustconfigure the AP's VLAN as the native VLAN. Access switch: (config-GigabitEthernet 0/2)#switchport trunk allowed vlan remove 1-9,11-19,21-4094//Transmittingdata from the STA VLAN and AP VLAN. Access switch: (config-GigabitEthernet 0/2)#end access switch# write VLAN pruning can also be performed on the port used to connect the accessswitch and the AC, to transmit data only from required VLANs. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
