Forgot password?
 Register now

Welcome to use this form to feedback your problems with Ruijie Community

The category of your feedback

Your Feedback

Your Email address (optional):

RG-EG1510XS Make a particulr VLAN in my network going out to a selected ISP provider under balanced load mode Reply

Daniel Mendez

Level 1

RG-EG1510XS Make a particulr VLAN in my network going out to a selected ISP provider under balanced load mode
238 1 2025-4-14 01:48:47
Original
Hello:
I created a particular VLAN for Video IPTV, I also have a balanced load  through 3 ISP ´s for all traffic, ISP1, ISP2, ISP3. I want to go out with VLAN for IPTV through a particular ISP 1 provider. Rest of the traffic, must be balanced.
How can I do that in the router RG-EG1510XS

Regards
RG-EG1510XS

Router
0 2025-4-15 09:40:11 View all replies
To configure a specific VLAN on the [strong]RG-EG1510XS[/strong] to route traffic through a selected ISP provider under [strong]balanced load mode[/strong], follow these steps:

Step 1: Configure the VLAN
Access the eWeb management platform of the RG-EG1510XS.
Navigate to Gateway > Config > Network> LAN> LAN Settings.
Create the VLAN:
Assign a [strong]VLAN ID[/strong] and configure the [strong]IP address[/strong] and [strong]subnet mask[/strong] for the VLAN.
Example:
  • VLAN ID: 20
  • IP Address: 192.168.20.1
  • Subnet Mask: 255.255.255.0
Save the configuration.

Step 2: Configure WAN Interfaces
Go to Gateway > Basics> WAN.
Configure the WAN interfaces for your ISP providers:
Assign the appropriate IP addresses, subnet masks, and gateway information for each WAN interface.
Example:
  • WAN0: ISP1
  • WAN1: ISP2
Save the configuration.

Step 3: Set Load Balancing Mode
Navigate to Gateway > Basics > ISP/Load Settings.
Select Balanced Mode.
Configure the weight for each WAN interface:
Example:
  • WAN0 Weight: 3
  • WAN1 Weight: 2
This ensures traffic is distributed proportionally (e.g., 60% on WAN0 and 40% on WAN1).
Save the configuration.

Step 4: Bind VLAN to a Specific WAN

Go to Gateway > Config> Network > LAN > LAN Settings.
Locate the VLAN you created (e.g., VLAN 20).
Bind the VLAN to the desired WAN interface:
Example: Bind VLAN 20 to [strong]WAN0[/strong] (ISP1).
Save the configuration.

Step 5: Verify the Configuration
Test the network to ensure that traffic from the specific VLAN is routed through the selected ISP provider.
Monitor the traffic distribution under Gateway > Monitor >Traffic Statistics.

Related Posts
Product Model

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

©2000-2023 Ruijie Networks Co,Ltd