EG105G-V3 port mapping with two WAN lines
|
Hello,I have this router installed with two WAN lines, throught two LTE routers. It configured to receive DHCP. The problem is that the EG105 can´t perform port mapping because the IPs it detects throught the WAN ports are local. The configured DDNS service correctly detects the public IP. I think the problem is that I can´t put the LTE routers in bridge mode, but I'm not entirely sure. Any idea ?. Regards. |
|
Dear Sir, Thank you again for your inquiry. I would like to confirm again that the EG obtains the intranet address under the LTE router and is not directly connected to the ISP network, right? And then we hope to do port mapping on EG, right? I wish you a happy life! Best regards, Eric |
Edited by Joe SIO at 2025-7-2 01:33 GTAC-Eric replied at 2025-7-1 10:02The problem is solved, I have replaced the LTE routers(RG-EW300T) , with others (DLINK DWR921) that would allow me to configure them in bride-ethernet mode. Now successfully performs DDNS resolution and port mapping. Best regards |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
