Using specific WAN alternatives
|
I have an EG310GH-E with two RG-ES224GC and one RG-ES226GC-P switches and several RAP2260(G) access points. Is there a way to create a wifi signal that goes through a specific WAN? Ideally I create a WIFI0 signal that goes through WAN0 and WIFI1 that goes through WAN1. Is this isn't the way, maybe 2 VLANs and one has as primary loading of WAN0 and the other has WAN1? Thank you. |
|
Edited by GTAC-Jason at 2025-7-18 03:33 Hello, Load balancing only permits 4 different policies, but they don't fit your requirement:  It may be possible to achieve your requirement by choosing "Based on Src and Dest IP Address" policy and create 2 static routes to forward one VLAN segment to the public IP of WAN0 and the other segment to WAN1. Best regards. Jason. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
