Wan configuration for Starlink
|
Edited by Lilian Zarzoso at 2025-7-18 00:27 Hello, I need to install Starlink as 2nd Wan on an RG-EG105G-V3 (192.168.1.0/24). The first wan is provided by a 4G modem on Wan0 (192.168.0.0/24) The Starlink has the bypass activated but I'm not sure wich configuration I have to apply when I convert the Lan3 in Wan1: *Not configurated (Starlink says the bypass act like a direct Wan, disabling DHCP & Wifi) *Static IP (with no gateway??) *DHCP (of course not) *PPOE (Starlink doesn't provide this kind of credentials) I can't change the gateway Ruijie, I need it in 192.168.1.0/24 I haven't found any topic related on the web, and the first connection of the Starlink crashed the Ruijie gateway. I must do it remotely and don't want to crach it once again. Hope that somebody should give me the right answer, many thanks |
|
Edited by GTAC-Arturo at 2025-7-19 03:49 in Bypass Mode Lan3→ WAN1, set to DHCP ]Add static route:
here is a link to our WAN configuration guide on your Ruijie EG device https://reyee.ruijie.com/en-global/support/documents/slide_rg-eg-series-routers-reyeeos-2340-configuration-guide/?page=html&keyworks=WAN#_Toc198217055
|
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
