How to set rssi threshold on Ruijie AP？

How to set rssi threshold on Ruijie AP？

Can use the command as below to set the associate rssi and response rssi

Ruijie#config ter

Ruijie(config)#interface dot11radio 1/0

Ruijie(config-if-Dot11radio 1/0)#response-rssi 20   ----->access Minimum RSSI

Ruijie(config-if-Dot11radio 1/0)#assoc-rssi 28 ---Minimum associated RSSI

And then you can use 'show dot a a' command to check the RSSI of users.

Notice:

If the STA’s RSSI is lower than the certain value,

AP will kick out the STA. We may use the command

"debug sta-mng dump-kick-sta"  to check the kick-out record.

If there is a kick-out record of the STA existing already,

the STA will not be kicked out in 10 mins.

Hi Chenlin,
Can you Please explain more details about this


assoc-rssi 28 ---Minimum associated RSSI

CHEN ZI WEI replied at 2023-5-5 21:07
Hi Chenlin,
Can you Please explain more details about this

Dear sir
I will check it and reply to you ASAP.
Best regards
Jenny

CHEN ZI WEI replied at 2023-5-5 21:07
Hi Chenlin,
Can you Please explain more details about this

Dear sir

Associated RSSI: If the average RSSI of a STA in a period is lower than the associated RSSI, the STA will be kicked offline.



Best regards

Jenny

what is the best range value of rssi?

Rehmat ICS replied at 2023-5-11 01:36
what is the best range value of rssi?

Dear sir

Normally AP deployment needs to ensure that the coverage intensity is above -75dbm.


You can set the associated RSSI as 25.

Note:
RSSI refers to the received signal strength, ranging from 0 to 100 (the corresponding wireless user signal strength is -95 based on this, such as the associated RSSI value is 25, the corresponding wireless user signal strength is 25 - 95 = -70dBm).



Best regards

Jenny