Forgot password?
 Register now

Welcome to use this form to feedback your problems with Ruijie Community

The Category of your Feedback

Your Feedback

Your Email Adress(optional)


How to Setup WAN Load Balance on RG-EG Reply
How to Setup WAN Load Balance on RG-EG
3024 1 2021-4-22 15:27:43

0 2021-6-28 16:56:16 View all replies
WAN Load Balance
The load balancing function distributes the data to multiple WAN interfaces to avoid the traffic congestion and provide redundancy.
1.Network Topology

2.Configuration Key Points
1. Configure IP address of the WAN ports and default routes.
2. Enable the load balancing policy.
3. Customize interface weight to ensure that traffic goes through the different egress according to weight.
3.Configuraiton Steps
Step 1: Configure WAN 0

Step 2: Change the LAN1 port to WAN port

Step 3: Configure WAN 1

Step 4: Enable Load Balance
Step 5: Configure the interface weight

4.Configuration Verfication

Advice to add the following configuration to convert to reachable link when one of link can't be reached

IP address: The IP need to be reached

Next Hop IP: The gateway IP of your  WAN port IP

Share this topic to


This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

©2000-2023 Ruijie Networks Co,Ltd