Why were no network address translation (NAT) entries displayed after I ran the show ip nat translation command on the RSR77 router? |
The RSR77 router is a distributed router. You can view NAT entries by using any of the following methods: 1. Display NAT translation entries on specified line card on which NAT outside interface is configured such as Ruijie#sh ip nat translations slot 2/1. 2. Log in to the specified line card on which NAT outside interface is configured and display NAT translation entries using commands show ip nat translation or show ip fpm flow (which displays NAT traffic or non-NAT traffic). For example: Ruijie#vtty 3/1 [LC3/1]>en [LC3/1]#show ip nat translation Note: The show ip nat translation command may return many results, which are displayed by screen. If the pipe operator (|) is added to the end of the command to filter results, the returned results will not be displayed by screen, which may lead to frequent screen refresh. The show ip nat translation command may affect services on a device with a large number of sessions; therefore, avoid using the command during peak hours. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd