Stopped working after applying configurations
|
Edited by donets@arena-mo.ru at 2021-6-2 14:39 [size=14.6667px]Good day! After applying the settings on the ports, I stopped connecting to the switch. There were attempts to reset the settings through the console, now it is completely unmanageable even through the console. [size=14.6667px] [size=14.6667px]Model: xs-s1960-10gt2sfp-ph [size=14.6667px] [size=14.6667px] [size=14.6667px]Please help! the device is new, purchased from the supplier. [size=14.6667px] |
|
Dear sir, The device may enter testing mode, please try to refer to the following guide to recover1. restart switch 2. press Ctrl+C to enter uboot 3. key in 4, --》4.scattered utilitles 4. key in 3, --》3.advanced settings 5. key in 6, --》6.Set RGOS mode 6. will show the following output Switch RGOS to factory mode. Erasing SPI flash...Writing to SPI flash...done And then you can restart the switch. It will work. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
