Please select To the mobile version | Continue to access the desktop computer version
 Forgot password?
 Register now


Reyee

View: 414|Reply: 0

[Router] How to configure Smart Flow Control and Custom policy on Reyee-Gateway

[Copy link]

Digests

Posts

0

Credits

TAC

Rank: 9Rank: 9Rank: 9

Credits
0
Post time 2021-8-27 15:35:48 | Show all posts |Read mode
How to configure Smart Flow Control and Custom policy on Reyee-Gateway

Smart Flow Control

Reyee Smart Flow Control is a feature used to avoid congestion by optimizing user traffic. The working principle is shown as below: when the total user traffic is low than the maximum WAN bandwidth, the rate limit policy will not be applied, every user will get the required bandwidth; However, when the total user traffic exceeds the maximum WAN bandwidth, the user-based rate limit will take effect. The total WAN bandwidth will be equally allocated to every user. For example, If there are 10 users in the network, the total user traffic is 200Mbps and WAN bandwidth is 100Mbps, every user will get 10Mbps bandwidth after enabling the smart flow control feature.

Configuration Steps
Step 1: Choose Gateway Advanced Flow Control and enable the feature.


Step 2: Fill in the WAN bandwidth and Save the configuration.


Custom policy(After enable Smart Flow Control)
Step 1: Choose Gateway Advanced Flow Control and enable the feature Custom Policy and add policy

Note:The bandwidth mode can be independent or shared. The difference between the two is as follows:
Sharing mode: IP address/range share the bandwidth configured below
Independent mode: each user in the IP address/range is the bandwidth value configured below

Step 2: Policy entry appears


Note:
Custom flow control has a higher priority than smart flow control
Custom flow control matching order: the post-configuration is effective, as long as one match is matched, it will no longer be matched downwards



Reply

Use magic Report

You have to log in before you can reply Login | Register now