Forgot password?
 Register now

Welcome to use this form to feedback your problems with Ruijie Community

The category of your feedback

Your Feedback

Your Email address (optional):

What can I do if it the wireless signal is poor after I have configured EST Bridge? Reply

GTAC-Jenny

Level 2

What can I do if it the wireless signal is poor after I have configured EST Bridge?
3655 6 2022-1-29 12:15:37
Original
a) Check the bridge environment: whether the distance between devices is too far, whether there is any obstruction between them, or whether the wireless radio is disturbed.  


b) Check the wireless setting and adjust the channel and the transmit power setting on the Wireless setting page.


Note:
In CPE mode, the local channel and its channel width are consistent with the peer channel and its channel width.
RG-EST350

Troubleshooting wireless signal Wireless-Bridge
0 2024-6-1 14:08:58 View all replies
does choosing the shorter distance in the parameter helps a stronger signal?

0 2024-6-1 14:16:06 View all replies
Kevin Bryan Laurea replied at 2024-6-1 14:08
does choosing the shorter distance in the parameter helps a stronger signal?

Dear sir

If the distance between devices is short, the higher the power configured, the better the signal strength. However, the devices must be aligned face to face
Because if the devices are facing the opposite direction, the signal between them will be poor at this time
you man refer to this pic


0 2024-6-1 14:21:50 View all replies
GTAC-Ross replied at 2024-6-1 14:16
Dear sir

If the distance between devices is short, the higher the power configured, the better th ...



i mean, what's the purpose of distance parameter here? does it affect the signal?

0 2024-6-1 14:33:37 View all replies
Kevin Bryan Laurea replied at 2024-6-1 14:21
i mean, what's the purpose of distance parameter here? does it affect the signal?
This is just a convenient way to set the correct ACK Timeout for your link. It does not change anything regarding signal.
Just make sure it is higher than the real distance.

0 2024-6-1 14:54:10 View all replies
Kevin Bryan Laurea replied at 2024-6-1 14:21
i mean, what's the purpose of distance parameter here? does it affect the signal?

Dear sir


It depends on the EST how far they're actually bridging
If the distance between EST is more than 1km, and the configuration shows 1km, the bridge between EST will fail

Best regards,
Ross

0 2024-6-1 15:51:23 View all replies

oh i see, so what happens if the distance between EST is 500m, then you choose 5km?

Related Posts
Product Model

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

©2000-2023 Ruijie Networks Co,Ltd