Introduction of IPsec VPN
IPsec VPN is used for Site to Site scenario. For example, three branches of a company are distributed in three different places of the internet. And every branch uses a gateway to establish tunnels with everyone, and the data between the corporate intranets (several PCs) is securely interconnected through the IPSec VPN tunnel established by these gateways.
(1) on the HQ side:
a Log in to Reyee EG by the default IP 192.168.110.1.
b Click Setup > VPN > IPSec > Add the policy.
c Configure the IPsec VPN Security Policy.
(2) on the Branch side:
a Log in to the Reyee EG by the default IP 192.168.110.1.
b Click Setup > VPN > IPSec and then Add the policy.
c Configure the IPSec Security Policy, make sure the IKE Policy and Connection Policy are same on both side.
d Check IPSec Connection Status.
● If you HQ EG has no public IP configured under other external devices, you need to configure port mapping on external devices and configure Local ID Type as NAME on HQ and Branches.
Could you please increase some quality of demonstrate pictures? because it's not cleary and blur|
WittawatVonghangool replied at 2022-7-26 21:16
Sorry for the inconvenience to your reading. You also can check the full content of this post in the 118 page of Reyee Series Implementation Cookbook V1.0 - Wireless - ruijienetworks. The picture in the Cookbook is more clearly.
Share this topic to
©2000-2022 Ruijie Networks Co,Ltd