Forgot password?
 Register now

Welcome to use this form to feedback your problems with Ruijie Community

The category of your feedback

Your Feedback

Your Email address (optional):

How to configure L2TP over IPsec VPN on Reyee EG? Reply

GTAC-Daisy

Level 1

How to configure L2TP over IPsec VPN on Reyee EG?
3804 0 2022-2-8 06:24:26
Original

Introduction of L2TP over IPsec VPN

l   L2TP over IPsec VPN usually is used for the Site to Site scenario and Client to Site scenario. For example, three branches of a company are distributed in three different places of the Internet, and everyone uses a gateway to establish tunnels with each other, and the data between the corporate intranets (several PCs) is securely interconnected through the L2TP over IPSec VPN tunnel established by these gateways, the staff who work at home can access company data through L2TP over IPSec VPN tunnel too.

Application Scenario

Clients to Site Scenario & Site to Site Scenario   

(1) On the HQ side:

a   Log in to Reyee EG by the default IP 192.168.110.1.

b   Click Setup->VPN->L2TP and choose IPsec Security.

    Note


●        PPP Hello Interval:The interval between hello messages on PPP over IPsec connection
●        IPsec Auth: Whether to encrypt the tunnel or not.
●        Pre-shared Key:A pre-shared key is required for IPsec encryption.
●        Local ID Type:When your HQ WAN port set with public IP, you can choose IP, when your HQ WAN port set with private IP, you need to choose name and set DMZ on external device.

c   Configure VPN clients and set clients, one is for branch EG, another is for PC.

    Note


●        PC-to-Router: PC-to-router connection is established between a PC and an terminal
●        Router-to-Router: Router-to-router VPN typically creates a direct, unshared and secure connection between two terminals.


1.19.1 Clients side Configuration

(1) On the Clients side (take Windows 10 as example):

a      Enter Control Panel→Network and Internet→Network and Sharing Center

b      Configure VPN connection

   

c      Change adapter’s setting.

d    Click Advanced Settings to configure the pre-shared password.

e    Using the account of PC-to-Router to connect VPN.

1.19.2  Branch side Configuration

(1) On the Branch side:

a      Log in to the Reyee EG by the default IP 192.168.110.1.

b      Click Setup->VPN->L2TP and then enable IPsec Auth.   

c      Configure the IPsec Security, make sure the pre-share password, IKE Policy and Transform Set is the same on both side.

d      Check the status of L2TP over IPsec Connection.


There are no replies.
Releated Posts
Product Model

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

©2000-2023 Ruijie Networks Co,Ltd