How to configure load balance on Ruijie/Reyee EG?

Click How to Setup WAN Load Balance on Reyee EG to configure load balance on Reyee EG.
Here are the detailed configure steps to configure  load balance on Ruijie EG:
Introduction of WAN Load Balance
The load balancing function distributes the data to multiple WAN interfaces to avoid the traffic congestion and provide redundancy.
Case of configuration
a) Network Topology

b) Configuration Key Point
1) Configure IP address of the WAN ports and default routes.
2) Enable the load balancing policy.
3) Customize interface weight to ensure that traffic goes through the different egress according to weight.
C) Configuraiton Steps1) Configure WAN 0

2) Change the LAN1 port to WAN port

3) Configure WAN 1

4) Enable Load Balance

5) Configure the interface weight for two link




Configuration Verfication

Advice to add the following configuration to convert to reachable link when one of link can't be reached


IP address： The IP need to be reached

Next Hop IP: The gateway IP of your  WAN port IP

is this the same as configuration in NBR series and EG Series?

NosSon replied at 2024-4-30 10:06
is this the same as configuration in NBR series and EG Series?

Dear sir

Yes, this is same configuration guide for NBR and Ruijie EG
However, different versions of the interface may be different
you can also refer to the WAN load balancing configuration via this link for NBR:
https://reyee.ruijie.com/en-global/resources/preview/reyee-rg-nbr-series-routers-web-based-configuration-guide

Best regards,
Ross

GTAC-Ross replied at 2024-4-30 10:19
Dear sir

Yes, this is same configuration guide for NBR and Ruijie EG

Thank you for your response.

how about the Failover?