|
Card (Supervisor Module) Insertion Operation (Wear ESD Gloves or an ESD Wrist Strap in Daily Operations). |
|
Step 1: Confirm the models and slots of cards and supervisor modules, as well as positions of guide rails.
Step 2: Turn the self-locking lever to a position vertical to the panel of a card (supervisor module).
Step 3: Hold the card (supervisor module) with hands, keep it parallel to the chassis, and insert it into the correct slot till it is locked by the self-locking lever.
Step 4: Hold the self-locking lever, insert the card (supervisor module) along the motion trail of the self-locking lever till the card (supervisor module) is completely inserted into the chassis.
Step 5: Use a screwdriver to tighten screws on the left and right sides of the card (supervisor module).
|
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 4
