Forgot password?
 Register now

Welcome to use this form to feedback your problems with Ruijie Community

The Category of your Feedback

Your Feedback

Your Email Adress(optional)

Products

How to enable the third radio of AP740-I? Reply
How to enable the third radio of AP740-I?
8771 4 2017-7-5 16:25:27
How to enalbe the third radio of AP740-I?

0 2017-7-5 16:51:54 View all replies
The third radio of AP740-I support wireless user access, the default is off. After the third radio configuration is bound to WLAN, the WLAN signal is not broadcasted by default. The third radio need to be enabled manually by the command:

extra-coverage enable.

Radio3 as 5G access, can only work in the 5.1G band (36-60). Radio2 work in 5.8G (149-165). Radio1/2 transmit power up to 50%.

Radio3 as 2.4G access, dual 2.4G only supports channel 1 and (11 or 13), 20M bandwidth configuration. Radio1 transceiver antenna up to 3 send 3 receive, the maximum transmit power up to 25%. Radio2 transmit power up to 50%.

[no | default] extra-coverage enable, AP configuration mode or AP group configuration mode, configure the AP switch third radio user access function, the default is off. The command belongs to the tri-state switch, convenient single AP/AP group/all AP combination configuration, default to default (inherited from the previous priority configuration, show run will not show), no enable (active off, show run will display), no prefix enable (active open state, show run will display).
channel-switch radio-id1 radio-id2, AP configuration mode, configure the specified two same types of Radio by the specified AP to switch the channel configurations.








0 2018-8-21 11:15:09 View all replies
Please, whats the command line to check activity on radio 3? sh dot11 associations all-client ???

0 2018-8-21 14:47:53 View all replies
Hi,Sir

Steps to enable 3rd radio for coverage on controller:
AC(config)#ap-config 740
AC(config-ap)#extra-coverage enable

Verification:
Telnet to designated AP740, and check whether the AP is broadcasting SSID with radio3
740#sh dot11 mbssid  

or you can exec" show ap-config summary" to verify whether have STAs connect to 3rd radio

0 2018-8-24 04:50:55 View all replies
Oscar replied at 2018-8-21 14:47
Hi,Sir

Steps to enable 3rd radio for coverage on controller:

Thank you!

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

©2000-2022 Ruijie Networks Co,Ltd