Forgot password?
 Register now
Products

How to configure policy-based route on EG? Reply
How to configure policy-based route on EG?
364 0 2022-7-2 15:16:13
I want VLAN 1 go through WAN 1, VLAN 2 go through WAN 2, how can I do it?


You can use the policy route to do it, for example
     vlan 1 is 192.168.1.0   vlan 2 is 192.168.2.0.
     WAN 1 is 10.100.10.1,  gateway is 10.100.10.254
     WAN 2 is 10.100.11.1,gateway is 10.100.11.254


Step 1 click route policy-base route, click add ACL



Step 2, Add two ACL 10 and 11,set ACE to permit 192.168.1.0 and 192.168.2.0






Step 3 Configure Policy route


Finished

RG-EG2100-P v2

Router
There are no replies.

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

©2000-2022 Ruijie Networks Co,Ltd