|
Static mode: AC1>enable AC1#configure terminal AC1(config)#interface range gigabitEthernet 0/1-2 ------>configure a range of interfaces with the same command AC1(config-if-range)#port-group 1 ------>put G0/1 and G0/2 in AP 1 in static mode AC1(config-if-range)#exit AC1(config)#interface aggregateport 1 AC1(config-if-AggregatePort 1)#switchport mode trunk ------>configure AP 1 as Trunk AC1(config-if-AggregatePort 1)#exit AC1(config)#aggregateport load-balance src-mac ------>modify load balance method to Src-MAC. By default, it is Src-Dst-MAC. AC1(config)#exit Dynamic mode: AC1(config)#interface range gigabitEthernet 0/1-2 AC1(config-if-range)#port-group 1 mode active ------>put G0/1 and G0/2 in AP 1 in dynamic mode AC1(config-if-range)#exit AC1(config)#interface aggregateport 1 AC1(config-if-AggregatePort 1)#switchport mode trunk ------>configure AP 1 as Trunk AC1(config-if-AggregatePort 1)#end AC#wr |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
