Forgot password?
 Register now
Products

How to configure PBR on Reyee EG? Reply
How to configure PBR on Reyee EG?
64 0 2022-8-1 13:17:46
Scenario
Multi-egress traffic distribution is applicable to a network with two or more operator lines. It controls data from different users to pass through specified external network lines, thereby implementing distribution of Internet access traffic.
Network Topology



Configuration Planning
1. The ISP1 line is connected to the WAN0 port (WAN): the static IP address is 172.26.5.185/22, and the external network gateway is 172.26.4.1;
2. The ISP2 line is connected to the WAN1 port (WAN1): the static IP address is 192.168.34.56/24, and the external network gateway is 192.168.34.1.
3. The IP address of the Internal server is 192.168.1.200, and the gateway is 192.168.1.1
4. The EG has 2 external ISP lines, which have been configured to access the Internet normally. The requirement is to realize that the internal network server 192.168.1.200 access the Internet through the ISP1 line.
Configuration Steps


1. Configure Internet access for two external ISP lines:Select Basics >WAN, Go to WAN configuration. Select Dual-Line, configure the IP address, subnet mask, extranet gateway, and DNS for each line, and click Save.






2. Configure PBR: Select  Advanced>Routing  >PBR, click Add to configure PBR parameters.




Rule Name: Set a rule name up to 28 characters long.
Protocol Type: Select or customize a protocol.
Protocol Number: Set a protocol number for the custom protocol.
Src Port Range: Set a source port range.
Dest Port Range: Set a destination port range.
Src IP/IP Range: Set a source IP address or range. Default: all IP addresses.
Dest IP/IP Range: Set a destination IP address or range. Default: all IP addresses.
Outbound Interface: Select an interface which PPTP packets are routed over.
Status: Enable or disable a policy.
Match Order: The packet flow will be matched with the rule from up to down until there is a successful match. You can move a rule up or down.
Test
On the server 192.168.1.200 tracert external network address to test whether the route trace is correct

Note:
Route Priority: PBR > Static Routing > ISP Routing.
RG-EG105G-P

Router Configuration PBR
There are no replies.

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

©2000-2022 Ruijie Networks Co,Ltd