|
Requirements: When an EG device is on the dual-network line, the active/standby failover can be implemented automatically through routing Topology:  Set interface 192.168.100.1 as the primary interface, and all traffic goes through the interface first. When the interface fails, all traffic switchover to the 100.68.0.1 interface. Configuration Steps: Step 1: Click Network > Route/Load > IP-Based Route >Add Static Route to add two default routes.  Step 2: Configure the route settings. The destination network and submask are both 0.0.0.0, but different next hops must be associated. Ensure that one is the primary route and the other is the backup route.   Step 3: Click Network > Interface > Link Detection, enable link detection function  |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 4
