Insufficient power Ruijie 2260G

detect alarm Insufficient power on cloud, and device detect log reboot. help please..

Dear sir
Because this model needs the 802.3at PoE, so it's insufficient power if you were using 802.3af PoE. The insufficient power will cause lots of problems. So please confirm the power supply of RAP2260G

GTAC-Wayne replied at 2022-8-17 09:45
Dear sir
Because this model needs the 802.3at PoE, so it's insufficient power if you were using 802. ...

hi sir.

Thank you for the information.
please info, POE Adaptor type for ruijie 2260(G) .

Thank you..

unknown unknown replied at 2022-8-17 10:50
hi sir.

Thank you for the information.

Hi sir, thank for the reply, you can use the RG-E-130(GE) as the poe power supplier for this AP. Here is the information for that.




https://www.ruijienetworks.com/resources/preview/74033

GTAC-Wayne replied at 2022-8-17 14:05
Hi sir, thank for the reply, you can use the RG-E-130(GE) as the poe power supplier for this AP. H ...

Hi Sir,

thank you very much, problem solved

GTAC-Wayne replied at 2022-8-17 14:05
Hi sir, thank for the reply, you can use the RG-E-130(GE) as the poe power supplier for this AP. H ...

Hello.
I have the same situation here (message from G1RUCGP057162 Power supply is insufficient), RAP2260.
The power supply that came with it is the REYEE RG-POE-50-60W-MG BT 56V DC.
Is this correct or is it the same case as above?

If it's not this power supply, is that why the 5Ghz network isn't showing up for me (as I mentioned in the other topic)?

Sergio  Neves replied at 2024-1-5 01:51
Hello.
I have the same situation here (message from G1RUCGP057162 Power supply is insufficient), R ...

Dear:
As my colleague explained before
,  the PoE protocol that needs to be used is 802.3at:

And your PoE injector supports this protocol.
If you can not see the 5GHz band on your side, please try to change the PoE protocol your AP currently uses:


Regards,

Javier

GTAC--Javier replied at 2024-1-5 08:51
Sergio  Neves replied at 2024-1-5 01:51
Hello.
I have the same situation here (message from G1RUCGP0 ...

Hello Javier.

I made the suggested change and it worked! The message no longer appeared and the 5Ghz is working.
Thanks!!!
Now, it's quite strange that it doesn't work correctly with the AUTO option.
I have 45 AP to configure and I'm going to have to do it one by one. >.<