Multiple Queries

Hi,

1. Is there anyway to change the default DNS and default NTP server for Ruijee APs, switches, routers - so that in case of a factory reset, the devices can by default communicate to the proper DNS server like 8.8.8.8 for google?
Also, default NTP server can be time.google.com?
2. I recently purchased the RG-AP180 series wall mounted APs. One of them had an older firmware and consequently, it is not able to connect to the ruijee network or check for firmware updates.

When I checked on the support website for new firmware I could not find the firmware files, the version that I found was different than the versions installed on my other series 180 APs.
Firmware on the website -

AP_RGOS11.9(6)W1B1,Release(09180101)


https://www.ruijienetworks.com/support/documents/slide_77276
Firmware on my existing APs -

AP_RGOS 11.9(4)B1, Release(06242719)
So is the version on my existing AP older? If yes, then why does it now show the new version available for download?
3. I have 2 Internet service providers and hence use 2 of the ports on my RG-EG3250 router.
ISP1 provides bandwidth of 100 Mbps. ISP2 provides 19 Mbps.

Is there a way to ensure that if ISP1 is down, and when ISP2 is active, then -
A. ISP2 becomes the failover backup.
B. There is an automatic speed limitation based on IP address (or range of IP address) for internet access through ISP2? And when ISP1 comes back, then the speed limitation goes away?
Thanks,
Ankit

Hi, sir
1-cant support to change the factory setting of DNS and NTP server for device
2-11.9(4)B1 is older, 11.9(6)W1B1 is the latest
3-
A- For the configuration of failover, you may check this post:
https://community.ruijienetworks.com/forum.php?mod=viewthread&tid=2482


B- You can set the flow control on the interface connected to ISP2.

For flow control, you can check this post:

https://community.ruijienetworks.com/forum.php?mod=viewthread&tid=3611&extra=page%3D1