RG-AP180 ports vlan setting

RG-AP180 how do i set the ports in this access point to specific vlan


ty

Dear sir,

RG-AP180 can set port to specific vlan by  following command.



Fat or MACC mode:

Login into AP, using the command as blew to configure the vlan of  AP interface:

AP>en

AP#config ter

AP(config)#vlan vlan-number

AP(config)#interface gi 0/1.1

AP(config-if-GigabitEthernet 0/1.1)#encapsulation dot1Q vlan-number

AP(config-if-GigabitEthernet 0/1.1)#ip dhcp snooping trust

AP(config-if-GigabitEthernet 0/1.1)#exit

AP(config)#interface gi 0/2

AP(config-if-GigabitEthernet 0/2)#encapsulation dot1Q vlan-number

AP(config-if-GigabitEthernet 0/2)#end

AP#wr

Fit mode:

WS6008>en

WS6008#config ter

WS6008(config)#ap-config ap-name

WS6008(config-ap)# wired-vlan 10 port 1 auto-save  //configure port 1 to vlan 10

WS6008(config-ap-config)#end

WS6008#write

Function support:

Through the wired-vlan command can configure the vlan of wired network interface used, the configuration only can be effectively on the AP which have wired network interface, the model of AP only Fit AP products:

They are AP110-W, AP120-W, AP120-S, AP130-W, AP130(L), AP130(W), MAP552,MAP552-W and AP3220-P.