|
You can use the following command to configuretrunk port and permit special VLANs on Ruijie switch. Ruijie>enable Ruijie#configure ter Ruijie(config)#interface g0/1 Ruijie(config-if-GigabitEthernet 0/1)#switchport trunk allowed vlan remove +number // After added, this vlan cannot pass theinterface Ruijie(config-if-GigabitEthernet 0/1)#switchport trunk allowed vlan only +number // After added, only this vlan passes throughthe interface Ruijie(config-if-GigabitEthernet 0/1)#switchport trunk allowed vlan add +number // After added, this vlan can pass throughthe interface (add the passed vlan on the original basis) Ruijie(config-if-GigabitEthernet 0/1)#switchport trunk allowed vlan except +number // After added, other vlans can pass theinterface except the vlan Ruijie(config-if-GigabitEthernet 0/1)#end Ruijie#wr |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 4
