How to configure multiple captive portals with Reyee EG?

Requirements:
VLAN 6: 192.168.6.0/24   Use captive portal template Staff
VLAN 7: 192.168.7.0/24   Use captive portal template Guest
Device:
Reyee EG with firmware ReyeeOS 202 or the later version.
Configuration Steps:  

Step 1: Make sure the Reyee EG is online on Ruijie Cloud and click its SN in the list to enter the configure page.

  Step 2: click the ‘Cloud portal Auth’ to configure the portal on Cloud

Notice:
Gateway P202 firmware is required.

Step 3: Enable the Auth firstly, then click Add to select the vlan which need to authenticate and choose the portal template to be used. In the end, click ‘save’ to save all configurations.

Select VLAN 6 and choose the portal template for VLAN 6,

Select VLAN 7 and choose portal template for VLAN 7

Notice: Exclude the IP of connected devices, it is recommend using different VLAN for users and devices.
Step 4: enter the Eweb of Reyee EG

Step 5: enter the ‘Authentication’ page of this Reyee EG, click the ‘Cloud Auth’, you can see the Authentication was enabled, and the IP range was synchronized here.

Notice:
If you want to change the IP range of the authentication, you may click Edit to change it:

It will synchronize to cloud:

Result Verification
Users connected to VLAN 6 and VLAN 7 will get a different portal authentication interface:

Thanks you so much!
Can this voucher auth run on LAN, without wifi APs?

Hiel Gagari replied at 2024-3-27 08:31
Thanks you so much!
Can this voucher auth run on LAN, without wifi APs?

Dear Hiel Gagari,

Yes, when you use Reyee EG as the authentication device, if the user devices are connected to LAN and get IP address of the authentication range. It will be required for authentication.

Best regards,
Jayden

GTAC-Jayden replied at 2024-3-27 09:09
Dear Hiel Gagari,

Yes, when you use Reyee EG as the authentication device, if the user devices ar ...

Thanks for confirming. Just implemented and its great!