EG105G-V2 _ Enable a WAN failover using LTE -
|
Good day Is it possible to use LTE as a wan failover, not load balance, But complete failover if there is no longer internet connection on WAN 0. Can WAN 1 be used as the next internet connection? Using A LTE router into the Ruijie Router WAN1. |
|
May I have your topology so that I can help you more efficiency？ |
Micca replied at 2023-1-30 09:48 WAN(isp) -> RG Gateway -> Ruijie AP. |
Zunaid replied at 2023-1-31 04:08 Dear sir You have two WAN ports on the eg, and want to set WAN0 as primary link and WAN1 as secondary link right? Best regards Jenny |
GTAC-Jenny replied at 2023-1-31 11:59 Hi Jenny that is correct, WAN 0 - Fibre Connection. WAN 1 LTE connection. Should fiber fail, it should jump over to LTE I have setup the dual WAN and but the failover still doesnt work. |
Zunaid replied at 2023-2-20 14:09 Dear sir You can follow this guide to achieve this function: https://community.ruijienetworks.com/forum.php?mod=viewthread&tid=4080&extra=page%3D1 Best regards Jenny |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
