Please select To the mobile version | Continue to access the desktop computer version
 Forgot password?
 Register now


Wireless

View: 2254|Reply: 1

My CRT can display the information, however I cannot input any command

[Copy link]

2

Digests

81

Posts

93

Credits

Staff

Credits
93
Post time 2018-4-3 15:16:15 | Show all posts |Read mode
hello, guys
My CRT can display the information, however I cannot input any command
what's wrong with it ?
what can I do ?


Reply

Use magic Report

10

Digests

994

Posts

1107

Credits

administrator

Rank: 9Rank: 9Rank: 9

Credits
1107
Post time 2018-4-3 15:48:12 | Show all posts
(1) Check whether the CRT orthe HyperTerminal is used. If CRT is used, uncheck CTS/RTS.
(2) If an additional cable is used, confirm whether the driver is installed correctly.
(3) Change the baud rate. The baud rate forthe version 1T8 is 115200 bps.
(4) Change the console cable and the PC.

Summary: Other faults caused by the CRT traffic control function (if you forget to close it).
(1) You can not use CRT to log on to the console.
(2) After CRT-based logon, the operation window is blank, the system outputs no information but the cursor flashes. The system has no response after you press Enter.
(3) After CRT-based logon, the operation window is blank, the system outputs no information but the cursor flashes.After you press Enter, the cursor moves but the system still outputs no information.
(4) After CRT-based logon, the system outputs information, but has no response after your press Enter and does not allow you to perform any operation.

Reply Support Not support

Use magic Report

You have to log in before you can reply Login | Register now