LACP fail between Ruijie S5760X switch and fortigate
|
Hello! I replaced cisco with ruijie switch. the lacp between cisco and fortigate was working but between ruijie and fortigate it is suspended. I used mode active same in cisco switch. |
|
Now it is working. Thank you! |
unknown unknown replied at 2023-4-6 11:49 Good job! Would you like to share your solution with us? |
GTAC-Sophia replied at 2023-4-6 12:04 At first I copied the configuration from cisco were the aggregated ports were in trunk mode, ip arp inspection trust and dhcp snooping trust. I just cleared (default) the configuration of the APs and added them again to the group. |
carlo@squarewave replied at 2023-4-6 12:30 Thank you for your sharing！👏👏👏 |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
