Forgot password?
 Register now

Welcome to use this form to feedback your problems with Ruijie Community

The category of your feedback

Your Feedback

Your Email address (optional):

When the wireless user speed limit fails, what should be done to check? Reply

GTAC-Sophia

Level 4

Ruijie Staff

When the wireless user speed limit fails, what should be done to check?
936 0 2023-7-25 11:49:52
Original


Check rate limitation configuration enabled by different devices
1. Rate limitation on Ruijie EG
(1) Check whether IP range is correct


2. Check If user enables Flow Control



3. If the user chooses the corresponding user group





4. Check whether users add the policy successfully




2. Rate limitation on Ruijie AP

AP-based rate limit:
Format: Fat AP(config)#wlan-qosap-based {per-user-limit | total-user-limit } {down-streams | up-streams}average-data-rate average-data-rate brust-data-rate brust-data-rate
FatAP(config)#wlan-qosap-based per-user-limit down-streams average-data-rate 800 burst-data-rate 1600

Wlan-based rate limit:
Format: Fat AP(config)#wlan-qoswlan-based {wlan-id | ssid} {per-user-limit | total-user-limit} {down-streams |up-streams} average-data-rate average-data-rate brust-data-rate brust-data-rate
FatAP(config)#wlan-qoswlan-based 1 per-user-limit down-streams average-data-rate 800 burst-data-rate 1600

Mac-based rate limit:
Format: Fat AP(config)#wlan-qosnetuser mac-address {inbound | outbound} average-data-rate average-data-rate burst-data-rate burst-data-rate
FatAP(config)#wlan-qosnetuser 0001.0001.0001 inbound average-data-rate 800 burst-data-rate 1600

Note: Check the commands are delivered successfully
Ruijie#show run---->check if the corresponding commands are taking effect?



3. Rate limitation on AC
Check the commands are delivered successfully.
AP-based rate limit:
Ruijie(config)#ap-configRJAP
Ruijie(config-ap)#ap-basedper-user-l
imitdown-streams average-data-rate 800 burst-data-rate 1600

Wlan-based rate limit:
AC(config)#wlan-config1 RL
AC(config-wlan)#wlan-basedper-user-limit down-streams average-data-rate 800 burst-data-rate 1600

Mac-based rate limit:
AC(config)#ac-controller
AC(config-ac)#netusermac-address   { inbound | outbound }average-
data-rateaverage-data-rate burst-data-rate burst-data-rate

AC#show dot11 ratelimit wlan
AC#show dot11 ratelimit user
AC#show dot11 ratelimit ap
4. Rate limitation on Reyee EG
rate limiationon Reyee EG





RG-AP720-I

Troubleshooting Wireless
There are no replies.
Releated Posts
Product Model

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

©2000-2023 Ruijie Networks Co,Ltd