When the wireless user speed limit fails, what should be done to check?

Check rate limitation configuration enabled by different devices
1.  
Rate limitation on Ruijie EG
1. Check whether the IP range is correct

2. Check If the user enables Flow Control

3. If the user chooses the corresponding user group

4. Check whether users add the policy successfully

2.
Rate limitation on Ruijie AP
AP-based rate limit:
Format：FatAP(config)#wlan-qosap-based {per-user-limit | total-user-limit } {down-streams | up-streams}average-data-rate average-data-rate brust-data-rate brust-data-rate
FatAP(config)#wlan-qos ap-based per-user-limit down-streams average-data-rate 800 burst-data-rate 1600

Wlan-based rate limit:
Format：FatAP(config)#wlan-qos wlan-based {wlan-id | ssid} {per-user-limit | total-user-limit} {down-streams |up-streams} average-data-rate average-data-rate brust-data-rate brust-data-rate
FatAP(config)#wlan-qos wlan-based 1 per-user-limit down-streams average-data-rate 800 burst-data-rate1600

Mac-based rate limit:
Format:FatAP(config)#wlan-qosnetuser mac-address {inbound | outbound} average-data-rate average-data-rate burst-data-rate burst-data-rate
FatAP(config)#wlan-qos netuser 0001.0001.0001 inbound average-data-rate 800 burst-data-rate 1600

Note: Check the commands are delivered successfully
Ruijie#show run---->check if the corresponding commands are taking effect？

3.
Rate limitation on AC
Check the commands are delivered successfully
AP-based rate limit:
Ruijie(config)#ap-configRJAP
Ruijie(config-ap)#ap-basedper-user-limit down-streams average-data-rate 800 burst-data-rate 1600

Wlan-based rate limit:
AC(config)#wlan-config1 RL
AC(config-wlan)#wlan-basedper-user-limit down-streams average-data-rate 800 burst-data-rate 1600

Mac-based rate limit:
AC(config)#ac-controller
AC(config-ac)#netuser mac-address   { inbound | outbound } average-data-rate average-data-rate burst-data-rate burst-data-rate

AC#show dot11 ratelimit wlan
AC#show dot11 ratelimit user
AC#show dot11 ratelimit ap
4. Rate limitation on Reyee EG

rate limiation on Reyee EG