Forgot password?
 Register now

Welcome to use this form to feedback your problems with Ruijie Community

The category of your feedback

Your Feedback

Your Email address (optional):

How to configure acl on ruijie switch? Reply

GTAC-Bancroft

Level 1

How to configure acl on ruijie switch?
2696 0 2023-8-11 10:09:16
Original
Apply the ACL on the switch uplink port to block the specific user accessing the Internet:

Ruijie>en      

Ruijie#config ter

Ruijie(config)#ip access-list extended 100

Ruijie(config-ext-nacl)#deny ip 192.168.10.0 0.0.0.255 any  //block 192.168.10.0 network access to the Internet

Ruijie(config-ext-nacl)#permit ip any any  //allow other resources

Ruijie(config-ext-nacl)#exit

Ruijie(config)#interface g0/1

Ruijie(config-if-vlan 10)#ip access-group 100 out  //Apply the ACL on the switch uplink port outdirection

Ruijie(config-if-vlan 20)#end      

Ruijie#write  //Save the config

RG-S5300-48GT4XS-E

Configuration Switch
There are no replies.
Related Posts
Product Model

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

©2000-2023 Ruijie Networks Co,Ltd