Forgot password?
 Register now

Welcome to use this form to feedback your problems with Ruijie Community

The category of your feedback

Your Feedback

Your Email address (optional):

How to check Channel Utilization parameters in Ruijie AP using CLI? Reply

GTAC-Bancroft

Level 1

How to check Channel Utilization parameters in Ruijie AP using CLI?
1548 0 2023-8-15 10:39:15
Original
You can check Channel Utilization parameters in Ruijie AP as follows:

AP version is greater than or equal to 11.1(5)B9 version

The following is an example (you need to enable the terminal monitor and log functions first) :

Ruijie#terminal monitor

Ruijie(config)#log on

Ruijie(config)#exit

Ruijie#debug sdk link 1 //1 indicates radio frequency card 1 (2.4g) and 2 indicates radio frequency card 2 (5g).

*Sep 22 03:47:54: %7: ChannelUsing = 14 %

*Sep 22 03:47:54: %7: Noise = -99 dBm

Rf card 1 channel utilization rate 14%, noise base -99dBm

RG-AP810-L

Configuration Wireless
There are no replies.
Related Posts
Product Model

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

©2000-2023 Ruijie Networks Co,Ltd