Issue facing after meshing my APs
|
I have connected three APs 2260G ,2200E,2200E,my master is 2260G ,the issue is that when my one of the slave disconnects,it doesn't connect with the master automatically and taking too much time,so what can be the problem? |
|
May I know did you enable enable Self-Healing Mesh function on salve AP? You can refer to this post: https://community.ruijienetworks.com/forum.php?mod=viewthread&tid=6678 |
GTAC-Micca replied at 2023-9-23 21:00 yes it' on. |
Muhammad Ahmed replied at 2023-9-25 15:22Facing the problem still |
Muhammad Ahmed replied at 2023-9-26 15:08 1. May I know the device distance pls? 2. If your device is managed by Ruijie Cloud, may you share the project with read&write permission to my email address pls? guominxiang@ruijie.com.cn 3. if it doesn't connect with the master automatically, may I know what did you do to make it mesh again? May you describe this progress for me pls? |
GTAC-Micca replied at 2023-9-27 14:30 The issue is resolved, the range of AP mesh in less than 10metres so it worked,the key was to update the firmware for meshing as it was'nt showing the option first but upgrade resolved it. |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
