2 vlans for wan interface

Im trying to setup 1 wan link with 2 vlans on the EG-105G router. The setup is such that the WAN will have 2 vlans from the same ISP. Would anyone know how to achieve this

Dear:

May I know the purpose of setting 2 VLANs in the WAN interface please?

If it is for an IPTV scenario, you may refer to the following link where it is explained how to set up IPTV on reyee EG:

https://community.ruijienetworks.com/forum.php?mod=viewthread&tid=1899


Regards,

Javier

GTAC--Javier replied at 2023-11-15 07:39
Dear:

May I know the purpose of setting 2 VLANs in the WAN interface please?

The setup we have is 1 Wan Link and 1 L2 VPN setup by the ISP to link our remote branches. Traffic of these 2 links is separate no wonder the need to have 2 VLAN's on the WAN interface.

GTAC--Javier replied at 2023-11-15 07:39
Dear:

May I know the purpose of setting 2 VLANs in the WAN interface please?

I have the same request.

In my case my ISP provides 2 vlans, 1 for internet and 1 for voip telephony.
They give us 2 vlans with 2 separate pppoe logins.


How to set that?

Thanks

E M replied at 2023-11-18 20:38
I have the same request.

In my case my ISP provides 2 vlans, 1 for internet and 1 for voip teleph ...

the same request too

GTAC--Javier replied at 2023-11-15 07:39
Dear:

May I know the purpose of setting 2 VLANs in the WAN interface please?

Hello User 9757 and Javier,
Me too have such scenario.

I have two Sites (Both Site A and Site B is connected with same ISP)
The ISP has placed two ONUs one for Site A & another for Site B to access both internet and cctvs. (cctvs of both site into single LAN).
The ISP's provided CDATA ONU has two ports i.e. LAN1 and LAN2.
On Each site ONU's LAN1 is connected to my RG-Eg series gateway router's WAN port used to access internet.
ON Each site ONU's LAN2 is connected to my RG-Eg series gateway router's LAN0 port used connect Site A's and Site B's cctv into single vlan subnet.
The DHCP server on Site B's RG-Eg series gateway router is disabled for cctvs vlan subnet.


Things are working well , but each time I login using either eweb or cloud to configure router, the topologies  consistent data is not ok alerts appeared.

Is there any other better configuration can we do so that no any warning alerts appeared and best performance can also be achieved too.  

Thanks