|
Edited by Oscar at 2018-6-26 11:58 Problem:While plugging a new line card or replacement, if the line card firmware version is mismatch with control engine(CM) card. It will prompt the warning message like this: 
Solution: 1.Download exact RGOS firmware file which chassis is running on USB's root direction and insert your USB to chassis. 2.Run reset command to reload the new line card, and chassis will upgrade it automatically after probing. N18-Core#reset module 1/1------1/1 means slot 1/1 3.Exec "show upgrade status" to verify upgrade process 4.Once the firmware upgrade is finished, exec the reset command again and the new line card will be loaded. N18-Core#reset module 1/1------1/1 means slot 1/1 |
2eac697b-9b16-4b5b-8a14-5f6132d309d6.jpg (137.22 KB, Downloads: 153)
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
