mesh connection
|
connect a UFO AP model RAP6262(G) with my EG105GW(T) router via mesh and from one moment to the next it goes offline, I have restored it, I connect it, the process begins and then it goes offline |
|
Dear, Good day. The connection between these devices via mesh is not possible, the AP cannot mesh with the EG, but it can mesh with other APs of the same series. Best regards |
AnaKarenDuranUrrutia replied at 2024-2-7 06:05 Dear, have reviewed, and the mesh connection between these devices is possible. If it cannot be established, you need to check the firmware version of the AP. Best regards |
Edited by Diego Restrepo at 2024-2-7 07:00 AnaKarenDuranUrrutia replied at 2024-2-7 06:24It worked yesterday for a while but then it stopped working, the version of both devices is 2.62.0.2404 I factory reset the AP and then I rescan the ACCESS POINT MESH, it finds the device, it starts to adopt it and then it shows that it is offline, I am doing this procedure 2 meters from the GW  |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
