RG-EG105G-P-V2 and IPv6

I need to close all IPv6 outbound/inbound traffic to the internet for a specific device(192.168.200.10) on the local network.
I look to the "IPv6 Interface Configuration" and I see there "Wan=No"
Does this mean that no IPv6 traffic should be allowed into my network for all devices? Or do I need to write some additional rule for 192.168.200.10?

Dear sir

if you want to block traffic of IPV6 devices
you can configure ipv6 based on the ip address here to block the traffic



Best regards,
ross

Thanks for the reply, but I can't find that section. Here is a screenshot from the app (Android) - there is no IPv6. I can't find these settings via Cloud Web Interface either

User 14205 replied at 2024-3-4 20:35
Thanks for the reply, but I can't find that section. Here is a screenshot from the app (Android) - t ...

Dear sir

this configuration of the web interface of the EG
currently for APP it can not be supported
sorry for the inconvenience

best regards
Ross