Fasttrack/Port Forwarding in Ruijie

Good day,

I was limiting my users to 10mbps down/up each. But I want that when they go to speedtest.net they will get the 700mbps network's speed, not the limit.

Mikrotik router has that, It's called IPv4 FastTrack. You will put the tcp/udp 8080 port that speedtest uses on the fastTrack under firewall.


It is possible to do this on my Ruijie Router? My router is Model: EG105G-P.

you can refer to flow control of this web guide:
https://www.ruijienetworks.com/resources/preview/ruijie-reyee-rg-eg-series-routers-web-based-configuration-guide-release-reyeeos-2-248-en

GTAC-Micca replied at 2024-3-7 16:13
you can refer to flow control of this web guide:
https://www.ruijienetworks.com/resources/preview/r ...

Thank you for the response. Yes, that's for the limiting of the speed.

But what about when they speedtest? I need a port forwarding where I can port forward the speedtest port so I can bypass it.

User 34956 replied at 2024-3-7 16:48
Thank you for the response. Yes, that's for the limiting of the speed.

But what about when they s ...

You want users to speed limit at 10Mbps, but when they use speedtest, they get a higher speed, not 10Mbps only, right?
If yes, you can configure like this:
1. set user speed limit policy with 10Mbps as normal configure from the guide.
2. set speedtest as "no limit"


3. Channel Priority of speedtest rule to 0

GTAC-Micca replied at 2024-3-7 20:02
User 34956 replied at 2024-3-7 16:48
Thank you for the response. Yes, that's for the limiting of the ...

Thank you very much. My other concern is solved too, the priorities of the categories

Update:

I've tried it but I still get 10mbps on speedtest.