Mesh with bridge mode?
|
Edited by erwin weah at 2024-6-4 08:24 My ISP modem (192.168.100.1) doesn't allow to change the Subnet mask, it must be 255.255.255.0, so it is possible to change the RG-EW1800GX PRO IP to 192.168.100.101, 192.168.100.102, 192.168.100.103? The reason we have to use same subnet mask because our network has shared printer and drive that using wired connection and it should be available via wired or wireless.  |
|
Dear sir You can configure the EW wan port settings to static IP address via More> Switch to PC view> More> Basics> WAN  In static ip mode, you need to enter the IP address, subnet mask, gateway, and DNS server to save the config successfully. Best regards Jenny |
|
Dear sir You can also configure wired repeater mode on the EW router to make all of the devices in the same network segment. Here is the guide to configure wired repeater mode on the EW router on page 48: https://reyee.ruijie.com/en-global/resources/preview/ruijie-reyee-home-wi-fi-range-extender-web-based-configuration-guide  Best regards Jenny |
GTAC-Jenny replied at 2024-6-4 11:03 I will try, thanks |
This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.
More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.
©2000-2023 Ruijie Networks Co,Ltd
Level 1
