Forgot password?
 Register now

Welcome to use this form to feedback your problems with Ruijie Community

The category of your feedback

Your Feedback

Your Email address (optional):

【Typical Case】How to Troubleshoot VLAN Redirection Failures Due to GPSK Issues in a Scenario Including WS6008 and AP820-L(V2)? Reply

GTAC-Sophia

Level 5

Ruijie Staff

【Typical Case】How to Troubleshoot VLAN Redirection Failures Due to GPSK Issues in a Scenario Including WS6008 and AP820-L(V2)?
167 0 2024-10-31 10:55:11
Original
Keywords:

WS6008,GPSK, VLAN Redirection
Issue Description

(1) An SSID is bound to VLAN 100, and a GPSK account is bound to VLAN 200.


(2) A wireless client obtains an IP address of VLAN 100 instead of VLAN 200 after connecting to the SSID using the GPSK password.

Device Model and Firmware

  Device Type
  
  Device Model
  
  Device Version
  
  Wireless  access controller (AC)
  
  WS6008
  
  AC_RGOS  11.9(6)W3B1, Release(11160200)
  
  Access  point
  
  AP820-L(V2)
  
  AP_RGOS  11.9(6)W3B1, Release(11160201)
  
Cause Analysis

1.Check if the device model and version support GPSK by reviewing the specifications of both the current and latest versions. If the current version does not support GPSK, upgrade to a version that does. If it supports GPSK, proceed with troubleshooting.
2. Check the configurations on the AC.

Run the show sumng psk-group name xxx command on the AC to check whether the account is configured properly.
Run the show ac-c c command to check whether VLAN redirection is normal on the AC.
In addition to the preceding configurations, run the following commands on the AC to apply the VLAN group to the WLAN. Otherwise, wireless users cannot be redirected to the corresponding VLAN after successful authentication using the GPSK account.

vlan-group10

vlan-list 100,200

default-vlan100

ap-group defaul


interface-mapping1 group 10 ap-wlan-id 1


Root Cause

After configuring GPSK on eWeb, run the related commands on the AC to add the target VLAN to the VLAN group and bind the VLAN group to the WLAN.
Solution

Run the following commands on the AC:
vlan-group10
vlan-list 100,200 // If the customer has other VLANs, add them as required.
default-vlan100 // This is the default VLAN.
ap-group defaul
interface-mapping1 group 10 ap-wlan-id 1 //Bind the VLAN group to the WLAN.
RG-AP820-L(V2)

Troubleshooting Wireless
There are no replies.
Related Posts
Product Model

Share this topic to

Cancel

This site contains user submitted content, comments and opinions and is for informational purposes only. Ruijie may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Ruijie can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Ruijie disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the Ruijie Community Terms of Use.

More ways to get help: Visit Support Videos, call us via Service Hotline, Facebook or Live Chat.

©2000-2023 Ruijie Networks Co,Ltd